收藏

康星板换除垢剂-普锐特 3.785L 5-150倍稀释 4/箱

正品保障 售后无忧 准时发货
  • 已选:
    普锐特 3.785L   1.00

温馨提示 · 过滤芯、过滤桶、过滤器等非质量问题出货后一律不退不换

商品编号: 124809
库存情况: 有货
商品产地: 诸暨
生产厂商: 康星化工

查看[普锐特板换除垢剂]商品组中其它1个商品

商品介绍

属性信息

使用说明

质量保证

普锐特:板换专用清洗剂

STOCK No.90-331   4×1G(3.785L)

Lime “+”: Plate Heat Exchanger Cleaner

康星专用板式换热器等精密系统, 可用于拆卸式大型板换系统,亦可适用焊接式整机化学清洗,且对不锈钢等无腐蚀。Lime “+”: Plate Heating Exchanger Cleaner,developed by adopting advance technology from the United States, can effectively clean large dismantled or welded plate exchanger system, and no corrosion to stainless steel, etc.

产品特点

●  去除种无机盐污垢,如水垢、锈渍、水泥渍以及石灰渍等

●  相对大部分酸性清洗剂更安全、有效;在推荐的条件下对不锈钢无腐蚀

●  专用于去除如空调热交换器设备等要求相对较高的清洗

FEATURES

●Effective removal of various inorganic soils, such as scale, rust, cement and lime, etc.

●Safer and more effective comparing with most acid cleaners and non-corrosive to stainless steel under recommended conditions.

●Dedicated to some fine cleaning such as heat exchange equipment cleaning of air conditioner.

使用方法(焊接式整机化学清洗)

1.对板换进行反冲洗:关闭进出水阀门,断开进水口,打开出水口阀门,冲洗3-5分钟去除不牢固的锈垢、粘泥等,也可使用康星粘泥剥离剂除锈渣与粘泥;

2.清洗液配制:对板换小循环清洗,1:5~15,对板换热水侧系统大循环清洗,按1:30~50;对板换冷水侧系统大循环清洗,按1:100~150;

3.清洗时间:对板换小循环清洗半小时至1.5小时内完成,对板换大循环清洗不超过4小时(必须4小时内完成);

4.废液排除:在排除废液以前,请用酸洗中和剂中和至pH值7-8,进行污水排放;

5.用清水彻底冲洗系统半小时左右,以去除所有残留;

6.注满清水后,定期加入缓蚀阻垢一体剂和微生物杀灭剂,以便保养系统。

备:在清洗板换后,用康星酸洗宁9号对板换进行保护防腐蚀对系统更安全可靠!

DIRECTIONS

1.Backwash the plate (close the inlet and outlet valves, then disconnect the inlet, and open the outlet valve, rinse for 3-5 minutes) to remove loose rust, sludge, etc. ChemClean's High-efficient Sludge Stripper is recommended during this process.

2. Working liquid preparation: 1:5-15 for small cycle cleaning of plate exchanger; 1:30-50, for large cycle cleaning of hot water side exchange system; 1:100-150, for large cycle cleaning of cold water side exchange system.

3. Cleaning time:0.5~1.5 hours, for small cycle cleaning of plate exchanger;

≤4 hours, for large cycle cleaning of plate exchanger;

4. Liquid waste discharge: please neutralize liquid waste with acid pickling neutralizer to pH 7-8 before discharging in order to meet the national discharge standard.

5. Rinse the system thoroughly with clean water for about half an hour to remove all residues.

6. After filling clean water, the corrosion and scale inhibitor and microbial killer should be added regularly to maintain the system.

Note: cooperating with corrosion inhibitor Pickling Guard 09 could be safer and more reliable when cleaning plate heat exchanger with Lime Dissolver "Plus".

温馨提示:

康星产品更新产品包装标签,故现有存货有新旧包装交替出货,网上图片会陆续更新为新包装样式。收货有疑问的,请咨询相关业务员。

服务说明

正品保障 您所购买的产品由金牛制冷直供,保障正品!
售后无忧 用户在金牛制冷购得的产品如因特殊情况无法正常使用,我公司经确认后,将及时为您联系指定售后服务点,并根据实际情况为您提供退换货、维修服务。
准时发货 公司WMS系统多批次发货,保证了商品基本可以在24小时内发出。